Honda CR-V: Compass Calibration

If you see ‘‘- -’’ in the direction
display when you turn the ignition
switch to the ON (II) position, the
compass is self-calibrating.
The compass may need to be
manually calibrated after exposure to
a strong magnetic field. If the
compass display changes to ‘‘- -’’
and the calibrate indicator blinks, or
the display does not show any
direction and the compass is not selfcalibrating,
do the following.
1. Drive the vehicle slowly in three
complete circles.
NOTE: Do this procedure in an open area, away from buildings, power
lines, and other vehicles.
2. When the display goes from
‘‘- -’’ or blank to an actual
heading, the unit is calibrated and
the display returns to normal.
READ NEXT:
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
SEE MORE:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
WARNING
Compressed air mixed with the R-134a forms a
combustible vapor.
The vapor can burn or explode causing serious
injury.
Never use compressed air to pressure test
R-134a service equipment or vehicle air
conditioning systems.
CAUTION
Air conditioning refrigerant or lubricant vapor
ca
© 2016-2025 Copyright www.hcrv.net
