Honda CR-V: Accessory Power Sockets

Your vehicle has two or three

Your vehicle has two or three accessory power sockets depending on the model.

To use an accessory power socket,

To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).

None of the sockets will power an

None of the sockets will power an automotive type cigarette lighter element.

Make sure to put the socket cover

Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.

READ NEXT:

 Console Compartment

EX-L model Push the release knob to open or close the console compartment, slide the lid rearward.

 Coat Hook

To use a coat hook, slide it out slightly, then pull it down. Make sure the coat hook is folded up when you are not using it. This hook is not designed for large or heavy items.

 Seat Under Tray

If equipped Your vehicle has a seat under tray located under the front passenger seat. Use the tray by pulling on the front center edge of the tray.

SEE MORE:

 Maintain a Proper Sitting Position

After all occupants have adjusted their seats and head restraints, and put on their seat belts, it is very important that they continue to sit upright, well back in their seats, with their feet on the floor, until the vehicle is safely parked and the engine is off. Sitting improperly

 Seats

Component Location Index REAR SEAT Removal/Installation Armrest Removal/Installation Armrest Cover Replacement Right Rear Seat Cover Replacement Left Rear Seat Cover Replacement Right Seat-back Lock Control Cable Replacement FRONT SEAT Front Seat Active Head Restraint Inspect

© 2016-2025 Copyright www.hcrv.net