Honda CR-V: Brake System Indicator

The brake system indicator normally

The brake system indicator normally comes on when you turn the ignition switch to the ON (II) position, and as a reminder to check the parking brake. It will stay on if you do not fully release the parking brake.

If the brake system indicator comes on while driving, the brake fluid level is probably low. Press lightly on the brake pedal to see if it feels normal.

If it does, check the brake fluid level the next time you stop at a service station.

If the fluid level is low, take your vehicle to a dealer, and have the brake system inspected for leaks or worn brake pads.

However, if the brake pedal does not feel normal, you should take immediate action. A problem in one part of the system’s dual circuit design will still give you braking at two wheels. You will feel the brake pedal go down much farther before the vehicle begins to slow down, and you will have to press harder on the pedal.

Slow down by shifting to a lower gear, and pull to the side of the road when it is safe. Because of the long distance needed to stop, it is hazardous to drive the vehicle. You should have it towed and repaired as soon as possible (see Emergency Towing).

If you must drive the vehicle a short distance in this condition, drive slowly and carefully.

If the ABS indicator and the VSA system indicator come on with the brake system indicator, have your vehicle inspected by your dealer immediately.

READ NEXT:

 Fuses

The vehicle’s fuses are contained in three fuse boxes. The interior fuse box is located under the dashboard on the driver’s side. The fuse label is attached under the steering column.

 Checking and Replacing Fuses

If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages, or the diagram on the fuse box lid, which fuse or fuses control that d

 Fuse Locations

INTERIOR FUSE BOX UNDER-HOOD FUSE BOX

SEE MORE:

 Folding the Rear Seats Down

Each rear seat-back can be folded down separately to give more cargo room. With either of the outer seatbacks folded-down, you can still carry a passenger in the rear seat. With the center seat-back foldeddown, either outer seating position can be used. You can also fold up the left or

 Steering Gearbox Overhaul

Exploded View Special Tools Required Cylinder end seal remover attachment 070AF-S7S0100 Valve seal ring sizing tool 07NAG-SR3090A Sleeve seal ring guide 07YAG-S2X0100 Sleeve seal ring sizing tool, 36 mm 07ZAG-S5A0100 Attachment, 28 x 30 mm 07946-1870100 Driver 07749-0010000 Piston seal ri

© 2016-2025 Copyright www.hcrv.net