Honda CR-V: Dust and Pollen Filter
Honda CR-V (2006–2011) Owner's Manual / Maintenance / Dust and Pollen Filter
This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system.
Have your dealer replace this filter when this service is indicated by a maintenance message on the information display. It should be replaced every 15,000 miles (24,000 km) if you drive primarily in urban areas that have high concentrations of soot in the air, or if the airflow from the heating and cooling system/climate control system becomes less than usual.
READ NEXT:
Wiper Blades
Check the condition of the wiper
blades at least every six months.
Replace them if you find signs of
cracking in the rubber, areas that are
getting hard, or if they leave streaks
and unwiped
Tires
To safely operate your vehicle, your
tires must be the proper type and
size, in good condition with adequate
tread, and correctly inflated.
The following pages give more
detailed information
Inflation Guidelines
Keeping the tires properly inflated
provides the best combination of
handling, tread life, and riding
comfort.
Underinflated tires wear unevenly,
adversely affect handling and fuel
economy,
SEE MORE:
Shift Solenoid Valve
Shift Solenoid Valve Test
1. Connect the HDS to the DLC (A).
2. Choose Shift Solenoid A, B, C, D, and E in the
Miscellaneous Test Menu on the HDS.
NOTE: If the HDS does not communicate with the
PCM, troubleshoot the DLC circuit.
3. Check that shift solenoid valves A, B, C, D, and E
operate with t
Engine Compression Inspection
NOTE: After this inspection, you must reset the
powertrain control module (PCM), otherwise the PCM
will continue to stop the injectors from functioning.
Select PCM reset using the Honda Diagnostic System
(HDS).
1. Warm up the engine to normal operating
temperature (cooling fan comes on).
2. Turn t
© 2016-2025 Copyright www.hcrv.net
