Honda CR-V: Changing the Set Speed

You can increase the set cruising speed in any of these ways:

Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button.

To increase the speed in very small amounts, tap the RES/ ACCEL button. Each time you do this, your vehicle will speed up about 1 mph (1.6 km/h).

Push on the accelerator pedal.

Accelerate to the desired cruising speed, then press the SET/ DECEL button.

You can decrease the set cruising speed in any of these ways:

NOTE: If you need to decrease your speed quickly, use the brakes as you normally would.

To slow down in very small amounts, tap the SET/DECEL button. Each time you do this, your vehicle will slow down about 1 mph (1.6 km/h).

Press and hold the SET/DECEL button. Release the button when you reach the desired speed.

Tap the brake pedal lightly with your foot. The CRUISE CONTROL indicator on the instrument panel goes out. When the vehicle slows to the desired speed, press the SET/DECEL button.

Even with the cruise control turned on, you can still use the accelerator pedal to speed up for passing. After completing the pass, take your foot off the accelerator pedal. The vehicle will return to the set cruising speed.

Resting your foot on the brake pedal causes cruise control to cancel.

READ NEXT:

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

 Bluetooth HandsFreeLink

On models with navigation system Bluetooth HandsFreeLink (HFL) allows you to place and receive phone calls using voice commands, without handling your cell phone. To use HFL, you need a Bluet

SEE MORE:

 Multiplex Integrated Control System

Component Location Index GAUGE CONTROL MODULE Input Test Replacement IMMOBILIZER-KEYLESS CONTROL UNIT (Built in receiver) MICU (Built into the under-dash fuse/relay box) Input Test Replacement General Troubleshooting Information Troubleshooting CAN Circuit Related Problems NOT

 Airbag System Components

Airbag System Components Your airbag system includes: Two SRS (supplemental restraint system) front airbags. The driver’s airbag is stored in the center of the steering wheel; the front passenger’s airbag is stored in the dashboard. Both are marked ‘‘SRS AIRBAG’’ Two

© 2016-2025 Copyright www.hcrv.net