Honda CR-V: MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box.

2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Wipers/Washers

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Wipers/Washers

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. Wipers/Washers

READ NEXT:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

 Gauges

Component Location Index GAUGE CONTROL MODULE Self-diagnostic Function Input Test Rewriting the ODO Data and Transferring Smart Maintenance on a New Gauge Control Module Replacement Out

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition s

SEE MORE:

 Shifting

To shift from any position, press firmly on the brake pedal and the release button on the side of the shift lever. You cannot shift out of Park when the ignition switch is in the LOCK (0) or ACCESSORY (I) position. Park (P) - This position mechanically locks the transmission. Use

 Rear Window Defogger

Component Location Index UNDER-DASH FUSE/ RELAY BOX UNDER-HOOD FUSE/RELAY BOX REAR WINDOW DEFOGGER RELAY HVAC CONTROL UNIT REAR WINDOW DEFOGGER SWITCH/ MIRROR DEFOGGER SWITCH REAR WINDOW DEFOGGER Circuit Diagram Function Test NOTE: Be careful not to scratch or damage the defogger wire

© 2016-2025 Copyright www.hcrv.net