Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver Attachment Attachment, 40 x 50 mm Clutch spring Compressor Attachment Bearing Installer Attachment

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain tensioner. 4. To hold the rear balancer shaft, insert a 6 mm pin driver (A) into the maintenance hole

© 2016-2025 Copyright www.hcrv.net