Honda CR-V: Replacing a High-mount Brake Light Bulb
Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a High-mount Brake Light Bulb
1. Open the tailgate.
Unlatch the top of the cover by pulling back on it with your hands.
2. Place a cloth on the side edge of the cover to prevent scratches.
Remove the cover by carefully prying on the edge with a small flat-tip screwdriver and pulling the cover off.
3. Remove the socket from the light assembly by turning it one-quarter turn counterclockwise.
4. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.
5. Press the brake pedal to make sure the new bulb is working.
6. Put the socket back into the light assembly, and turn it clockwise to lock it in place.
7. Put the cover back on the light assembly. Push it in until it locks in place.
READ NEXT:
Cleaning the Seat Belts
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropy
Floor Mats
The floor mats that came with your
vehicle hook over the floor mat
anchors. This keeps the floor mats
from sliding forward, possibly
interfering with the pedals, or
backwards, making the f
Audio Antenna
Your vehicle is equipped with an
antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash,
remove the antenna by unscrewing it by
hand. This prevents the antenna
SEE MORE:
Idle Control System
Component Location Index
POWER STEERING PRESSURE (PSP) SWITCH
Signal Circuit Troubleshooting
A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
Signal Circuit Troubleshooting
POWERTRAIN CONTROL
MODULE (PCM)
General Troubleshooting Information
Replacement
A/C
Side Engine Mount Bracket Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the side engine mount bracket, then loosely
tighten the new bolt and nut (C), and loosely tighten
the bolt
© 2016-2025 Copyright www.hcrv.net
