Honda CR-V: Ventilation
The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate.
1. Set the temperature to the lower
limit.
2. Make sure the A/C is off.
3. Select
and fresh air mode.
4. Set the fan to the desired speed.
READ NEXT:
Using the Heater
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
1. Select
.
When you select
, the system
Using the A/C
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge. If it moves near the red zone,
turn off the A/C until the gauge
reading returns to normal.
1.
Dehumidify the Interior
Air conditioning, as it cools, removes
moisture from the air.When used in
combination with the heater, it
makes the interior warm and dry and
can prevent the windows from
fogging up.
1. Tur
SEE MORE:
Starting System
Component Location Index
STARTER CUT RELAY
UNDER-DASH
FUSE/RELAY BOX
STARTER
Starter Circuit Troubleshooting
Performance Test
Removal and Installation
Overhaul
TRANSMISSION RANGE SWITCH
Test
Replacement
Symptom Troubleshooting
Index
Engine
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lower arm (A).
NOTE: During installation, install a new flange bolt
and new flange nuts. After lightly
© 2016-2025 Copyright www.hcrv.net
