Honda CR-V: Evaporative Emissions Control System
As gasoline evaporates in the fuel
tank, an evaporative emissions
control canister filled with charcoal
adsorbs the vapor. It is stored in this
canister while the engine is off. After
the engine is started and warmed up,
the vapor is drawn into the engine
and burned during driving.
READ NEXT:
The onboard refueling vapor
recovery (ORVR) system captures
the fuel vapors during refueling. The
vapors are adsorbed in a canister
filled with activated carbon. While
driving, the fuel vapo
The exhaust emissions controls
include three systems: PGM-FI,
ignition timing control, and three
way catalytic converter. These three
systems work together to control the
engine’s combusti
The emissions control systems are
designed and certified to work together
in reducing emissions to
levels that comply with the Clean Air
Act. To make sure the emissions
remain low, you shoul
SEE MORE:
This switch is under the driver’s side
vent. To turn the VSA system on and
off, press and hold it until you hear a
beep.
When VSA is off, the VSA off
indicator comes on as a reminder.
Press and hold the switch again. It
turns the system back on.
VSA is turned on every time you
sta
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0111 is stored at the same time as DTC P1116,
troubleshoot DTC P0111 first, then recheck for DTC
P1116.
1. Check for poor connections or loose terminal
© 2016-2025 Copyright www.hcrv.net
