Honda CR-V: Engine Coolant Check
Honda CR-V (2006–2011) Owner's Manual / Before Driving / Service Station Procedures / Engine Coolant Check
Look at the coolant level in the radiator reserve tank. Make sure it is between the MAX and MIN lines. If it is below the MIN line, see Adding Engine Coolant on page for information on adding the proper coolant.
READ NEXT:
Actual Mileage and EPA Fuel Economy Estimates Comparison.
Fuel economy is not a fixed number.
It varies based on driving conditions,
driving habits and vehicle condition.
Therefore, it is not possible for one
set of estimates to predict fuel
economy
Fuel Economy Factors
The following factors can lower your
vehicle’s fuel economy:
Aggressive driving (hard acceleration and braking)
Excessive idling, accelerating and braking in stop-and-go traffic
Cold engine ope
SEE MORE:
Towing a Trailer
Your vehicle has been designed
primarily to carry passengers and
their cargo. You can also use it to
tow a trailer if you carefully observe
the load limits, use the proper
equipment, and follow the guidelines
in this section.
Break-In Period
Avoid towing a trailer during your
vehicle
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
© 2016-2026 Copyright www.hcrv.net
