Honda CR-V: Auto Door Locking

The auto door locking feature has three possible settings:

The auto door locking is deactivated all the time.

The doors and tailgate lock whenever you move the shift lever out of the Park (P) position.

The doors and tailgate lock when the vehicle speed reaches 9 mph (15 km/h).

This is the default setting.

To turn off the Auto Door Lock modes:

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and open the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door until you hear a click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Park Lock mode:

Locks all doors and tailgate when the shift lever is moved out of the Park (P) position.

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Drive Lock mode:

Locks all doors and tailgate when the vehicle’s speed reaches about 9 mph (15 km/h).

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the brake pedal, and move the shift lever out of the Park (P) position.

4. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

5. Release the switch, and within 20 seconds, turn the ignition switch to the ACCESSORY (I) position.

Move the shift lever to the Park (P) position.

6. Turn the ignition switch to the LOCK (0) position.

READ NEXT:

 Auto Door Unlocking

The auto door unlocking feature has five possible settings: The auto door unlocking is deactivated all the time. The driver’s door unlocks when you move the shift lever to the Park (P) pos

 Childproof Door Locks

The childproof door locks are designed to prevent children seated in the rear from accidentally opening the rear doors. Each rear door has a lock lever near the edge. With the lever in t

 Remote Transmitter

LOCK - Press this button once to lock all doors and the tailgate. Some exterior lights will flash once. When you push LOCK twice within 5 seconds, you will hear a beep to verify that the

SEE MORE:

 Fan Control

Select the fan speed by pressing either side of the fan speed control bar ( or ). The fan speed is shown in vertical bars on the display. Air Conditioning (A/C) Button This button turns the air conditioning on and off. You will see A/C ON or A/C OFF in the display. When you turn

 Component Replacement/Inspection After Deployment

NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.) Do not replace the ODS unit unless it is physically damaged or

© 2016-2025 Copyright www.hcrv.net