Honda CR-V: Accelerating and Braking

For better traction on all surfaces, accelerate slowly and gradually build up speed. If you try to start too fast on wet soil, mud, snow, or ice, you might not have enough traction to get underway, and you may dig yourself a hole. Starting with the shift lever in second (2) gear will help you have a smoother start on snow or ice.

Keep in mind that you will usually need more time and distance to brake to a stop on unpaved surfaces.

Avoid hard braking. Do not ‘‘pump’’ the brakes; let the anti-lock braking system pump them for you.

READ NEXT:

 Avoiding Obstacles

Debris in the road can damage your suspension or other components. Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep ho

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

SEE MORE:

 Valve, Spring, and Valve Seal Removal

Special Tools Required Valve spring compressor attachment 07757-PJ1010A Identify the valves and valve springs as they are removed so that each item can be reinstalled in its original position. 1. Remove the cylinder head. 2. Using an appropriate-sized socket (A) and plastic mallet (B), lightly tap

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, troubleshoot DTC P2422 first, then recheck for DTC P0451. 1. Turn the ignition switch ON (II). 2. Clear

© 2016-2026 Copyright www.hcrv.net