Honda CR-V: Seat Adjustments

LX and U.S. EX models

See pages for important safety information and warnings about how to properly position the seats and seatbacks.

Make all seat adjustments before you start driving.

To adjust the seat forward or

To adjust the seat forward or backward, pull up on the bar under the seat cushion’s front edge. Move the seat to the desired position, and release the bar. Try tomove the seat to make sure it is locked in position.

To change the seat-back angle of the

To change the seat-back angle of the front seat, pull up the lever on the outside of the seat bottom.

Once a seat is adjusted correctly, rock it back and forth to make sure it is locked in position.

The height of your driver’s seat is

The height of your driver’s seat is adjustable. To raise the seat, repeatedly pull up the lever on the outside of the seat cushion. To lower the seat, push the lever down repeatedly.

READ NEXT:

 Rear Seat Adjustments

To adjust the seats forward and backward, pull up on the lever under the seat cushion. After moving the seat, make sure it is locked into position. The angle of each rear seat-back can

 Armrests

Each front seat has an armrest on the side of the seat-back. To use it, pivot it down. The rear seat armrest is in the center of the rear seat. Pivot it down to use it.

 Cargo Pass-through

The rear center seat-back has a cargo area pass-through. To use the cargo area pass-through, pull up the release on top of the center seatback and fold it down. If your vehicle is equippe

SEE MORE:

 Power switch will not turn ON (No information display and no sound) (with navigation)

1. With the ignition switch ON (II), push the power switch ON to see if navigation unit turns ON. Does the navigation unit display operate properly, and does the audio sound normal? YES-Intermittent failure, the system is OK at this time. NO-Go to step 2. 2. Turn the ignition switch OFF. 3. Che

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (see step 21). 6. Disconnect the air fuel ratio (A/F) sensor connector and secondary heated oxygen sen

© 2016-2025 Copyright www.hcrv.net