Honda CR-V: Replacement Parts
Honda CR-V (2006–2011) Owner's Manual / Technical Information / Emissions Controls / Replacement Parts
The emissions control systems are designed and certified to work together in reducing emissions to levels that comply with the Clean Air Act. To make sure the emissions remain low, you should use only new Honda replacement parts or their equivalent for repairs. Using lower quality partsmay increase the emissions from your vehicle.
The emissions control systems are covered by warranties separate from the rest of your vehicle. Read your warranty manual for more information.
READ NEXT:
ThreeWay Catalytic Converter
The three way catalytic converter
contains precious metals that serve
as catalysts, promoting chemical
reactions to convert the exhaust
gasses without affecting the metals.
The catalytic conv
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘
SEE MORE:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
Receiver/Dryer Desiccant
Replacement
NOTE: Install the receiver/dryer as quickly as possible
to prevent the system from absorbing moisture from
the air.
1. Remove the A/C condenser.
2. Remove the cap (A) from the bottom of the A/C
condenser. Remove the O-ring (B) and the
desiccant (C).
3. Install the receiver/dryer in the reverse or
© 2016-2025 Copyright www.hcrv.net
