Honda CR-V: PCV System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PCV System
Component Location Index
- PCV VALVE
PCV Valve Inspection
1. Check the PCV valve (A), hoses (B), and connections for leaks or restrictions.
2. At idle, make sure there is a clicking sound from the PCV valve when the hose between the PCV valve and intake manifold is lightly pinched (A) with your fingers or pliers.
If there is no clicking sound, check the PCV valve washer for cracks or damage. If the washer is OK, replace the PCV valve and recheck.
PCV Valve Replacement
1. Disconnect the PCV hose.
2. Remove the PCV valve (A).
3. Install the parts in the reverse order of removal with a new washer (B).
READ NEXT:
EVAP System
Component Location Index
EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
Replacement
POWERTRAIN CONTROL MODULE (PCM)
General Troubleshooting Information
Replacement
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
SEE MORE:
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armrest (A) toward the right side, then
release the left pivot shaft (B) from the bushing (C).
3. Release
Towing Equipment and Accessories
Towing can require a variety of
equipment, depending on the size of
your trailer, how it will be used, how
much load you are towing, and
where you tow.
Discuss your needs with your trailer
sales or rental agency, and follow the
guidelines in this section. Also make
sure that all equip
© 2016-2025 Copyright www.hcrv.net
