Honda CR-V manuals

Honda CR-V: Text Data Display Function

Honda CR-V (2006–2011) Owner's Manual / Features / Playing a USB Flash Memory Device (Canadian EX model and EX-L model without navigation system) / Text Data Display Function

Each time you press the TITLE button, the display mode shows you in sequence, the folder name, the file name, the artist name, the album name, the song name, or name off (which turns off the text display).

The display shows up to 16 characters of the selected data. If the text data has more than 16 characters, you will see the first 15 characters and the > indicator in the display. Press and hold the TITLE button until the next 16 characters are shown.

FOLDER SELECTION - To select a different folder, press the button. button or Press the button.

Press the the next folder, and press the button to skip to the next folder, and press the beginning of the previous folder. button to skip to the beginning of the previous folder.

READ NEXT:

 To Change or Select Files

Use the SKIP button while a USB flash memory device is playing to change files. SKIP - Each time you press the (SKIP +) button, the system skips forward to the beginning of the next file.

 To Select a File from Folder and File Lists

You can also select a folder or file by using the VOL/SELECT knob. Push the VOL/SELECT knob to switch the display to the folder or file list, then turn the VOL/SELECT knob to select a folder

 To Stop Playing a USB Flash Memory Device

To play the radio when a USB flash memory device is playing, press the FM, AMor XMbutton. If a disc is in the audio unit, press the CD/AUX or CD button to play the disc.

SEE MORE:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until you release the lever. OFF - The wipers are not activated. INT - The wipers operate every few s

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2025 Copyright www.hcrv.net