Honda CR-V: Frame

Under-cowl Panel Replacement

NOTE: Take care not to scratch the body.

1. Remove these items:

2. Remove the bolts and nuts, disconnect the connector (A) and remove the grommet (B), then remove the under-cowl panel (C).

Honda CR-V. Frame

3. Install the under-cowl panel in the reverse order of removal.

Upper Dashboard Support Gusset Replacement

Upper Dashboard Support Gusset Torque

NOTE: Take care not to scratch the body.

Honda CR-V. Frame

Rear Damper Gusset Replacement

Rear Damper Gusset Torque

NOTE: Take care not to scratch the body.

Honda CR-V. Frame

Subframe Replacement

Front Subframe Torque

NOTE:

Honda CR-V. Frame

Rear Subframe Torque

NOTE:

Honda CR-V. Frame

Frame Repair Chart

Top View

Honda CR-V. Frame

Honda CR-V. Frame

Side View

Honda CR-V. Frame

Honda CR-V. Frame

READ NEXT:

 HVAC (Heating, Ventilation, and Air Conditioning)

Special Tools Backprobe set Component Location Index SERVICE VALVE (HIGH-PRESSURE SIDE) SERVICE VALVE (LOW-PRESSURE SIDE) EVAPORATOR CORE (Located-in the heater unit) RECEIVER/DRYER DESIC

 A/C Service Tips and Precautions

WARNING Compressed air mixed with the R-134a forms a combustible vapor. The vapor can burn or explode causing serious injury. Never use compressed air to pressure test R-134a service equipment

 System Description

The air conditioning system removes heat from the passenger compartment by transferring heat from the ambient air to the evaporator. The evaporator cools the air with the refrigerant that is circula

SEE MORE:

 Outside Temperature Indicator

If equipped This indicator displays the outside temperature in Fahrenheit (U.S. models) or Celsius (Canadian models). The temperature sensor is in the front bumper. Therefore, the temperature reading can be affected by heat reflection from the road surface, engine heat, and the

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control module (tach) (B) will usually blink. When the Honda Diagnostic System (HDS) is connected to the data l

© 2016-2025 Copyright www.hcrv.net