Honda CR-V: Parking Brake
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Parking Brake
To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again.
The parking brake indicator on the instrument panel should go out when the parking brake is fully released.
Driving the vehicle with the parking brake applied can damage the rear brakes and hubs. A beeper will sound if the vehicle is driven with the parking brake on.
READ NEXT:
Steering Wheel Adjustment
Make any steering wheel adjustment
before you start driving.
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
in
Keys and Locks
The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
box locked when you leave your
vehicle an
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly coded key (or other
device) is used, the engine’s fuel
system is disabled.
When you turn the ignition switch to
t
SEE MORE:
Nothing Happens or the Starter Motor Operates Very Slowly
When you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound, a series of clicks, or
nothing at all.
Check these things:
Check the transmission interlock.
The transmission must be in Park
o
DTC Troubleshooting
DTC B1000: Communication Bus Line Error
(Bus-off)
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Wait for 6 seconds or more.
4. Check for DTCs with the HDS.
Is DTCs B1000 and/or B1008 and B1011
indicated?
YES-Go to step 5.
NO-Intermittent failure, the
© 2016-2025 Copyright www.hcrv.net
