Honda CR-V: Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system.

Have your dealer replace this filter when this service is indicated by a maintenance message on the information display. It should be replaced every 15,000 miles (24,000 km) if you drive primarily in urban areas that have high concentrations of soot in the air, or if the airflow from the heating and cooling system/climate control system becomes less than usual.

READ NEXT:

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

 Tires

To safely operate your vehicle, your tires must be the proper type and size, in good condition with adequate tread, and correctly inflated. The following pages give more detailed information

 Inflation Guidelines

Keeping the tires properly inflated provides the best combination of handling, tread life, and riding comfort. Underinflated tires wear unevenly, adversely affect handling and fuel economy,

SEE MORE:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with the HDS. 2. Turn the. ignition switch OFF, and then back ON (II). 3. Operate the rear window wiper f

 Piston Ring Replacement

1. Remove the piston from the engine block. 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring or ring groove cleaner with a blade to fit the piston grooves. The top and 2nd ring grooves are 1.2 mm (0.05 in.) wide. Th

© 2016-2025 Copyright www.hcrv.net