Honda CR-V: Parking Brake
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Parking Brake
To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again.
The parking brake indicator on the instrument panel should go out when the parking brake is fully released.
Driving the vehicle with the parking brake applied can damage the rear brakes and hubs. A beeper will sound if the vehicle is driven with the parking brake on.
READ NEXT:
Steering Wheel Adjustment
Make any steering wheel adjustment
before you start driving.
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
in
Keys and Locks
The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
box locked when you leave your
vehicle an
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly coded key (or other
device) is used, the engine’s fuel
system is disabled.
When you turn the ignition switch to
t
SEE MORE:
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armrest (A) toward the right side, then
release the left pivot shaft (B) from the bushing (C).
3. Release
Valve, Spring, and Valve Seal Removal
Special Tools Required
Valve spring compressor attachment 07757-PJ1010A
Identify the valves and valve springs as they are
removed so that each item can be reinstalled in its
original position.
1. Remove the cylinder head.
2. Using an appropriate-sized socket (A) and plastic
mallet (B), lightly tap
© 2016-2025 Copyright www.hcrv.net
