Honda CR-V: Floor Mats

The floor mats that came with your

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective.

If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle.

If you use a non-Honda floor mat, make sure it fits properly and that it can be used with the floormat anchors. Do not put additional floor mats on top of the anchored mats.

READ NEXT:

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

SEE MORE:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with the HDS. 2. Turn the. ignition switch OFF, and then back ON (II). 3. Operate the rear window wiper f

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in very small amounts, tap the RES/ ACCEL button. Each time you do this, your vehicle will speed up

© 2016-2025 Copyright www.hcrv.net