Honda CR-V: Parking Brake
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Parking Brake
To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again.
The parking brake indicator on the instrument panel should go out when the parking brake is fully released.
Driving the vehicle with the parking brake applied can damage the rear brakes and hubs. A beeper will sound if the vehicle is driven with the parking brake on.
READ NEXT:
Steering Wheel Adjustment
Make any steering wheel adjustment
before you start driving.
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
in
Keys and Locks
The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
box locked when you leave your
vehicle an
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly coded key (or other
device) is used, the engine’s fuel
system is disabled.
When you turn the ignition switch to
t
SEE MORE:
DLC Circuit Troubleshooting
NOTE: Make sure the HDS and the DLC cable of the
HDS is not defective.
1. Turn the ignition switch OFF.
2. Connect the HDS to the DLC.
NOTE: Make sure the HDS is properly connected to
the DLC.
3. Turn the ignition switch ON (II). and read the HDS.
Does the HDS identify the vehicle?
YES-Go to ste
Troubleshooting
Troubleshooting - B-CAN System
Diagnosis Test Mode A
Check the PCM for DTCs, and troubleshoot PCM or F-CAN loss of communication errors
first, then do this diagnosis if the symptom is related to
the B-CAN system.
NOTE: Always cycle the ignition switch within
3 seconds when prompted in the DTC troub
© 2016-2025 Copyright www.hcrv.net
