Honda CR-V: Checking Loads

The best way to confirmthat all loads are within limits is to check them at a public scale. For public scales in your area, check your local phone book, or contact your trailer dealer or rental agency for assistance.

If you cannot get to a public scale, you can estimate the total trailer weight by adding the weight of your trailer (as quoted by the manufacturer) with everything in or on the trailer.

If you normally pull the same load each time you tow a trailer, you can use a suitable scale or a special tongue load gauge to check the tongue load the first time you set up a towing combination (a fully loaded vehicle and trailer), then recheck the tongue load whenever the conditions change.

READ NEXT:

 Towing Equipment and Accessories

Towing can require a variety of equipment, depending on the size of your trailer, how it will be used, how much load you are towing, and where you tow. Discuss your needs with your trailer

 Pre-Tow Checklist

When preparing to tow, and before driving away, be sure to check the following: The vehicle has been properly serviced, and the suspension and the cooling system are in good operating condi

 Driving Safely With a Trailer

The added weight, length, and height of a trailer will affect your vehicle’s handling and performance, so driving with a trailer requires some special driving skills and techniques. For y

SEE MORE:

 Camshaft Inspection

NOTE: Do not rotate the camshaft during inspection. 1. Remove the rocker arm assembly. 2. Put the rocker shaft holders, camshaft, and camshaft holders on the cylinder head, then tighten the bolts, in sequence, to the specified torque. NOTE: If the engine does not have bolt 21, skip it and continu

 Transfer Assembly Inspection/Removal/Installation

Transfer Assembly Inspection 1. Shift the transmission into the N position. 2. Raise the vehicle on a lift, and make sure it is supported securely. 3. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C). 4. Separate the propeller shaft from the transfer

© 2016-2025 Copyright www.hcrv.net