Honda CR-V: Ventilation

The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate.

1. Set the temperature to the lower limit.
2. Make sure the A/C is off.
3. Select 4. Set the fan to the desired speed. and fresh air mode.
4. Set the fan to the desired speed.

READ NEXT:

 Using the Heater

The heater uses engine coolant to warm the air. If the engine is cold, it will be several minutes before you feel warm air coming from the system. 1. Select . When you select , the system

 Using the A/C

Air conditioning places an extra load on the engine. Watch the engine coolant temperature gauge. If it moves near the red zone, turn off the A/C until the gauge reading returns to normal. 1.

 Dehumidify the Interior

Air conditioning, as it cools, removes moisture from the air.When used in combination with the heater, it makes the interior warm and dry and can prevent the windows from fogging up. 1. Tur

SEE MORE:

 Symptom Troubleshooting

Low pressure indicator does not come on, and no DTCs are stored 1. Turn the ignition switch ON (II). 2. Check the low pressure indicator for several seconds when the ignition switch is turned ON (II). Did the indicator come on and then go off? YES-Go to step 3. NO-Go to step 8. 3. Turn the ignit

 DTC 82-14: No Signal From the Front Passenger's Weight Sensor (front inner side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 82-14 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From the SRS INSPE

© 2016-2025 Copyright www.hcrv.net