Honda CR-V: Checking Loads

The best way to confirmthat all loads are within limits is to check them at a public scale. For public scales in your area, check your local phone book, or contact your trailer dealer or rental agency for assistance.

If you cannot get to a public scale, you can estimate the total trailer weight by adding the weight of your trailer (as quoted by the manufacturer) with everything in or on the trailer.

If you normally pull the same load each time you tow a trailer, you can use a suitable scale or a special tongue load gauge to check the tongue load the first time you set up a towing combination (a fully loaded vehicle and trailer), then recheck the tongue load whenever the conditions change.

READ NEXT:

 Towing Equipment and Accessories

Towing can require a variety of equipment, depending on the size of your trailer, how it will be used, how much load you are towing, and where you tow. Discuss your needs with your trailer

 Pre-Tow Checklist

When preparing to tow, and before driving away, be sure to check the following: The vehicle has been properly serviced, and the suspension and the cooling system are in good operating condi

 Driving Safely With a Trailer

The added weight, length, and height of a trailer will affect your vehicle’s handling and performance, so driving with a trailer requires some special driving skills and techniques. For y

SEE MORE:

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

 F-CAN Circuit Troubleshooting

NOTE: Information marked with an asterisk (*) applies to the CANL line. 1. Turn the ignition switch OFF. 2. Jump the SCS line with the HDS. 3. Disconnect PCM connector A (44P), then disconnect the HDS. 4. Measure resistance between PCM connector terminals A36 and A37. Is there about 95- 116 Ω

© 2016-2025 Copyright www.hcrv.net