Honda CR-V: Accessory Power Sockets
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets
Your vehicle has two or three accessory power sockets depending on the model.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
READ NEXT:
Console Compartment
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
Coat Hook
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
Seat Under Tray
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
Rear Window Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
Do not damage the rear window defogger grid lines
and terminals.
1. Remove these items:
Tailgate lower trim panel
High mount brake light
Potential Vehicle Hazards
Carbon Monoxide poison from
engine exhaust. Be sure there is
adequate ventilation whenever you
operate the engine.
Burns from hot parts. Let the
engine and exhaust system cool
down before touching any parts.
Injury from moving parts. Do
not run the engine unless
instructed to do so.
© 2016-2025 Copyright www.hcrv.net
