Honda CR-V manuals

Honda CR-V: Daytime Running Lights

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Damper/Spring

Damper/Spring Removal and Installation Removal 1. Turn the ignition switch ON (II), then turn on the windshield wipers. Turn the ignition switch off when the wipers are near the A-pillars. 2. Raise the front of the vehicle, and support it with safety stands in the proper locations. 3. Remove th

 Heater Unit/Core Replacement

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service. 1. Make sure you have anti-theft codes for the audio system and the navigation system (if equipped). 2. Make sure the ignition is OFF, then disconnect the

© 2016-2025 Copyright www.hcrv.net