Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 Differential Disassembly

Special Tools Required Holder handle 07JAB-001020A Companion flange holder 07RAB-TB4010B 1. Remove the drain plug (A) and the oil filler plug (B) with sealing washers (C). 2. Raise the locknut tab (A) from the groove of the clutch guide, making sure the tab completely clears the groove to preve

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

© 2016-2025 Copyright www.hcrv.net