Honda CR-V: Turn Signal/Hazard Flasher

Component Location Index

Honda CR-V. Turn Signal/Hazard Flasher

Circuit Diagram

Honda CR-V. Turn Signal/Hazard Flasher

Honda CR-V. Turn Signal/Hazard Flasher

MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.

1. Check the No. 10 (7.5 A) fuse in the under-dash fuse/relay box. lf the fuse is blown, replace it and go to step 2.

2. Disconnect the under-dash fuse/relay box connectors E, F, G, P, Q, R, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Turn Signal/Hazard Flasher

Honda CR-V. Turn Signal/Hazard Flasher

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Turn Signal/Hazard Flasher

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. Turn Signal/Hazard Flasher

Hazard Warning Switch Test/Replacement

1. Remove the center vent.

2. Remove the hazard warning switch (A).

Honda CR-V. Turn Signal/Hazard Flasher

3. Check for continuity between the terminals in each switch position according to the table.

Honda CR-V. Turn Signal/Hazard Flasher

4. If the continuity is not as specified, replace the hazard warning switch.

READ NEXT:

 Interior Lights

Component Location Index With moon roof INDIVIDUAL MAP LIGHTS INTERIOR LIGHT SWITCH (Built into the moonroof switch) AMBIENT LIGHT (Built into the moonroof switch) CEILING LIGHT CARGO AREA LI

 Entry Lights Control System

Component Location Index With moonroof INDIVIDUAL MAP LIGHTS IGNITION KEY SWITCH IGNITION KEY LIGHT CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH FRONT PASSENGER'S DOOR SWITCH LEFT

 Power Windows

Component Location Index POWER WINDOW MASTER SWITCH (With built-in control unit) FRONT PASSENGER'S POWER WINDOW SWITCH FRONT PASSENGER'S POWER WINDOW MOTOR RIGHT REAR POWER WINDOW SWITCH RIGHT

SEE MORE:

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on either No.1 or No.2 propeller shaft (B). 3. Start the engine, and let it run until it warms up (the ra

 Recommended Tire Pressures

]The following chart shows the recommended cold tire pressures for most normal and high-speed driving conditions. Tire Size Cold Tire Pressure for Normal Driving 225/65R17 102T Front/Rear: 30 psi (210 kPa , 2.1 kgf/cm2 ) The compact spare tire pressure is: 60 psi

© 2016-2025 Copyright www.hcrv.net