Honda CR-V manuals

Honda CR-V: Instrument Panel Brightness

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness

You can change the instrument panel

You can change the instrument panel brightness only when the light switch is on.

Turn the knob on the lower part of the instrument panel to adjust the brightness.

You will hear a beep when maximum or minimum brightness is reached.

To reduce glare at night, the

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to Turning the select/ or Turning the select/. Turning the select/ reset knob fully to the right until you hear a beep will cancel the reduced brightness.

READ NEXT:

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

SEE MORE:

 Emergency Towing

If your vehicle needs to be towed, call a professional towing service or organization. Never tow your vehicle with just a rope or chain. It is very dangerous. On 4WD models The only way you can safely tow your vehicle is with flat-bed equipment. The operator will load Any other metho

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition switch OFF. 2. Remove the left kick panel. 3. Disconnect the under-dash fuse/relay box connectors.

© 2016-2025 Copyright www.hcrv.net