Honda CR-V: CD Changer Error Messages (EX-L model with navigation system)

Honda CR-V (2006–2011) Owner's Manual / Features / CD Changer (EX-L model with navigation system) / CD Changer Error Messages (EX-L model with navigation system)

If you see an error message in the

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer.

The chart on the right explains the error messages you may see in the display while playing a disc.

If you see an error message in the display while playing a disc, press the eject button. After ejecting the disc, check it for damage or deformation. If there is no damage, insert the disc again.

For additional information on damaged discs.

Insert a different disc. If the new disc plays, there is a problem with the first disc. If the error message cycle repeats and you cannot clear it, take your vehicle to a dealer.

The audio systemwill try to play the disc. If there is still a problem, the error message will reappear. Press the eject button, and pull out the disc.

READ NEXT:

 Playing a PC card (EX-L model with navigation system)

Playing a PC card (EX-L model with navigation system)

 To Play a PC Card

You operate the PC card player with the same controls used for the radio and the disc player. To load or play a card, the ignition switch must be in the ACCESSORY (I) or ON (II) position. T

 Loading a PC Card

The PC card slot is behind the navigation screen. To use the PC card player, press the OPEN button beside the screen. The screen folds back, and the PC card slot appears. Insert a PC card

SEE MORE:

 Relay and Control Unit Locations

Engine Compartment VSA MODULATOR-CONTROL UNIT AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY PCM RADIATOR FAN RELAY ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY ELD UNIT PGM-FI MAIN RELAY 1 (FI MAIN) UNDER-HOOD FUSE/RELAY BOX FAN CONTROL RELAY BLOWER MOTOR RELAY

 Symptom Troubleshooting

SRS indicator does not come on 1. Connect the HDS to the DLC. 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit. 4. Check for PGM-FI, Body Electrical, and SRS DTCs with the HDS. Are

© 2016-2025 Copyright www.hcrv.net