Honda CR-V: The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run.

Are you using a properly coded key? An improperly coded key will cause the immobilizer system indicator in the instrument panel to blink rapidly.

Are you using the proper starting procedure? Refer to Starting the Engine.

Do you have fuel? Check the fuel gauge; the low fuel indicator may not be working.

There may be an electrical problem, such as no power to the fuel pump. Check all the fuses.

If you find nothing wrong, you will need a qualified technician to find the problem. See Emergency Towing.

READ NEXT:

 Jump Starting

Although this seems like a simple procedure, you should take several precautions. A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Ke

 If the Engine Overheats

The reading of the vehicle’s temperature gauge should stay in the midrange. If it climbs to the red mark, you should determine the reason (hot day, driving up a steep hill, etc.). If the

 Low Oil Pressure Indicator

Low Oil Pressure Indicator This indicator should never come on when the engine is running. If it starts flashing or stays on, the oil pressure has dropped very low or lost pressure. Serio

SEE MORE:

 Torque Converter Housing

Mainshaft Bearing and Oil Seal Replacement Special Tools Required Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A Attachment, 62 x 68 mm 07746-0010500 Attachment, 72 x 75 mm 07746-0010600 Driver 07749-0010000 1. Remove the mainshaft bearing and oil seal using the adjustabl

 Power Door Locks

To lock all doors and the tailgate, push the top of the master door lock switch on either front door, pull the lock tab rearward on the driver’s door, or use the key on the outside lock on the driver’s door. Pushing the rear of either master door lock switch will unlock all door

© 2016-2025 Copyright www.hcrv.net