Honda CR-V: Replacing the Transmitter Battery

If it takes several pushes on the button to lock or unlock the doors and the tailgate, replace the battery as soon as possible.

Battery type: CR1616

To replace the battery:

1. Remove the screw at the base of

1. Remove the screw at the base of the transmitter with a small Phillips-head screwdriver.

NOTE: Be careful when removing this screw as the head of the screw can strip out.

2. Separate the transmitter by prying its middle seam with your fingernail.

3. Inside the transmitter, separate

3. Inside the transmitter, separate the inner cover from the keypad by carefully prying on the edge with a coin.

4. Remove the old battery and note

4. Remove the old battery and note the polarity. Make sure the polarity of the new battery is the same (+ side facing down), then insert it in the keypad.

An improperly disposed of battery can hurt the environment.

Always confirm local regulations for battery disposal.

5. Install the parts in reverse order.

As required by the FCC:

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Industry Canada Standard RSS-210.

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference that may cause undesired operation of the device.

READ NEXT:

 Tailgate

The tailgate will lock when you lock the driver’s door with the key, the remote transmitter, the master door lock switch, or the lock tab on the driver’s door. To unlock the tailgate, tur

 Unlocking the Tailgate

If the power door lock system cannot unlock the tailgate, unlock it manually. Place a cloth on the top side of the cover to prevent scratches, then use a small flat-tip screwdriver to rem

 Seats

SEE MORE:

 Interior Lights

Component Location Index With moon roof INDIVIDUAL MAP LIGHTS INTERIOR LIGHT SWITCH (Built into the moonroof switch) AMBIENT LIGHT (Built into the moonroof switch) CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH TAILGATE LATCH SWITCH LEFT REAR DOOR SWITCH FRONT PASSENGER'S DOOR S

 DTC P0706: Open in Transmission Range Switch Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HDS. 2. 4WD model

© 2016-2025 Copyright www.hcrv.net