Honda CR-V: Rear Window Wiper and Washer

1. OFF

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position.

2. Rotate the switch clockwise to turn the rear window wiper ON.

The wiper operates every 7 seconds after completing two sweeps.

3. Hold past ON to activate the rear window wiper a few times and to spray the rear window washer.

4. Rotate the switch counterclockwise also to spray the window washer and turn the wiper on.

When you shift the transmission to the reverse position with the front windshield wiper activated, the rear wiper operates automatically even if the rear wiper switch is off.

The rear window washer uses the same fluid reservoir as the windshield washer.

READ NEXT:

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

SEE MORE:

 Rear Differential

Special Tools Holder Handle Oil Seal Driver Attachment, 78 x 80 mm Attachment, 52 x 55 mm Companion Flange Holder Driver Component Location Index REAR DIFFERENTIAL MOUNT Replacement REAR DIFFERENTIAL ASSEMBLY Removal Disassembly Reassembly Installation REAR DIFFERENT

 Idle Control System

Component Location Index POWER STEERING PRESSURE (PSP) SWITCH Signal Circuit Troubleshooting A/C COMPRESSOR CLUTCH RELAY (RELAY SOCKET A) Signal Circuit Troubleshooting POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement A/C

© 2016-2026 Copyright www.hcrv.net