Honda CR-V: Important Handling Information
Your CR-V has higher ground clearance than a passenger vehicle designed for use only on pavement. Higher ground clearance has many advantages for off-highway driving. It allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate problems earlier.
These advantages come at some cost. Because your vehicle is taller and rides higher off the ground, it has a high center of gravity. This means your vehicle can tip or roll over if you make abrupt turns. Utility vehicles have a significantly higher rollover rate than other types of vehicles. In a rollover crash, an unbelted person is significantly more likely to die than a person wearing a seat belt. As a reminder, make sure you and your passengers always wear seat belts.
For information on how to reduce the risk of rollover, read ‘‘Driving Guidelines’’ of this manual and the Off-Highway Driving Guidelines section. Failure to operate your vehicle correctly might result in loss of control, a crash, or rollover.
READ NEXT:
Overview of Contents
Contents
A convenient reference to the
sections in this manual.
Your Vehicle at a Glance
A quick reference to the main
controls in your vehicle.
Driver and Passenger Safety
Important informat
Driver and Passenger Safety
This section gives you important
information about how to protect
yourself and your passengers. It
shows you how to use seat belts. It
explains how your airbags work. And
it tells you how to
SEE MORE:
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to damage or deform the brake
lines during removal and installation.
To prevent the brake fluid from flo
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor connections or loose pins at all
connectors related to the circuit that you are
troubleshooting. If
