Honda CR-V: Auto-tensioner Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Cylinder Head / Auto-tensioner Removal and Installation

Removal

1. Remove the chain case cover.

Honda CR-V. Cylinder Head

2. Turn the crankshaft counterclockwise to compress the auto-tensioner.

Honda CR-V. Cylinder Head

3. Align the holes on the lock (A) and the auto-tensioner (B), then insert a 1.2 mm (0.05 in.) diameter pin or lock pin (P/N 14511 -PNA-003) (C) into the holes. Turn the crankshaft clockwise to secure the pin.

Honda CR-V. Cylinder Head

4. Remove the auto-tensioner.

Honda CR-V. Cylinder Head

Installation

1. Install the auto-tensioner.

Honda CR-V. Cylinder Head

2. Remove the pin or lock pin (P/N 1451 1-PNA-003) from the auto-tensioner.

Honda CR-V. Cylinder Head

3. Remove old liquid gasket from the chain case cover mating surfaces, bolts, and bolt holes.

4. Clean and dry the chain case cover mating surfaces.

5. Apply liquid gasket, P/N 08717-0004,08718-0001, 08718-0003, or 08718-0009, evenly to the chain case mating surface of the chain case cover. Install the component within 5 minutes of applying the liquid gasket.

NOTE:

Honda CR-V. Cylinder Head

6. Install the chain case cover.

NOTE:

Honda CR-V. Cylinder Head

Chain Case Oil Seal Installation

Special Tools Required

1. Use the driver and attachment to drive a new oil seal squarely into the chain case to the specified installed height.

Honda CR-V. Cylinder Head

2. Measure the distance between the chain case surface and oil seal.

Oil Seal Installed Height: 33.0-33.7 mm (1.30-1.33 in.)

Honda CR-V. Cylinder Head

READ NEXT:

 Cam Chain Inspection

1. Remove the front wheels. 2. Remove the splash shield (see step 21). 3. Remove the drive belt. 4. Remove the cylinder head cover. 5. Set the No.1 piston at top dead center (TDC). The punch mark

 CKP Pulse Plate Replacement

1. Remove the front wheels. 2. Remove the splash shield (see step 21). 3. Remove the drive belt. 4. Remove the cylinder head cover. 5. Set the No.1 piston at top dead center (TDC). The punch mark

 Cylinder Head Cover Removal/Installation

Cylinder Head Cover Removal 1. Remove the intake manifold cover. 2. Remove the four ignition coils. 3. Disconnect the evaporative emission (EVAP) canister purge valve connector. 4. Remove the dipst

SEE MORE:

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition switch OFF. 2. Remove the left kick panel. 3. Disconnect the under-dash fuse/relay box connectors.

 Passenger's Tray Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Use the a

© 2016-2025 Copyright www.hcrv.net