Honda CR-V: Adjust the Head Restraints
Honda CR-V (2006–2011) Owner's Manual / Driver and Passenger Safety / Protecting Adults and Teens / Adjust the Head Restraints
Adjust the driver’s head restraint so the center of the back of your head rests against the center of the restraint.
Have passengers adjust their head restraints properly as well. Taller persons should adjust their restraint as high as possible.
Improperly positioning head restraints reduces their effectiveness and you can be seriously injured in a crash.
Make sure head restraints are in place and positioned properly before driving.
Properly adjusted head restraints will help protect occupants from whiplash and other crash injuries.
See page for how to adjust the head restraints and how the driver’s and front passenger’s active head restraints work.
READ NEXT:
Fasten and Position the Seat Belts
Insert the latch plate into the buckle,
then tug on the belt to make sure the
belt is securely latched. Check that
the belt is not twisted, because a
twisted belt can cause serious
injuries
Maintain a Proper Sitting Position
After all occupants have adjusted
their seats and head restraints, and
put on their seat belts, it is very
important that they continue to sit
upright, well back in their seats, with
their f
Advice for Pregnant Women
If you are pregnant, the best way to
protect yourself and your unborn
child when driving or riding in a
vehicle is to always wear a seat belt,
and keep the lap part of the belt as
low as
SEE MORE:
Steering Angle Sensor Replacement
NOTE: Do not damage or drop the combination switch as the steering angle
sensor is sensitive to shock and vibration.
1. Remove the steering wheel.
2. Remove the steering column covers and the cable reel.
3. Remove the combination switch assembly.
4. Remove the combination light switch (A) and t
Oil Pan Removal
1. If the engine is already out of the vehicle, go to step
20.
2. Raise the vehicle on the lift to full height.
3. Drain the engine oil.
4. Remove the front wheels.
5. Remove the splash shield (see step 21).
6. Disconnect the air fuel ratio (A/F) sensor connector
and secondary heated oxygen sen
© 2016-2025 Copyright www.hcrv.net
