Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / Fan, Fan Motor, Shroud Removal and Installation

Removal

1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position.

Honda CR-V. Cooling System

2. Remove the bulkhead cover.

3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C).

Honda CR-V. Cooling System

4. Remove the radiator upper brackets (A), then remove the front bulkhead (B).

Honda CR-V. Cooling System

5. Remove the condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B) from condenser fan shroud side.

Honda CR-V. Cooling System

6. Disassemble the fan shrouds.

Honda CR-V. Cooling System

Installation

1. Assemble the fan shrouds.

Honda CR-V. Cooling System

2. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).

Honda CR-V. Cooling System

3. Install the front bulkhead (A), then install the radiator upper brackets (B).

Honda CR-V. Cooling System

4. Apply body paint to the bulkhead mounting bolts.

5. Connect the fan motor connectors (A) and hood switch connector (B), then install the harness clips (C).

Honda CR-V. Cooling System

6. Remove the bulkhead cover.

READ NEXT:

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

 Fuel and Emissions

SEE MORE:

 General Troubleshooting Information

DTC (Diagnostic Trouble Codes) The self-diagnostic function of the SRS system allows it to locate the causes of system problems and then store this information in memory. For easier troubleshooting, this data can be retrieved via a data link circuit. When you turn the ignition switch ON (II), the

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doin

© 2016-2026 Copyright www.hcrv.net