Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 Transmission Mount Replacement

1. Loosen the upper torque rod mounting bolt (A). 2. Remove the air cleaner housing assembly. 3. Remove the powertrain control module (PCM) cover, then remove the three bolts securing the PCM. 4. Remove the PCM bracket. 5. Support the transmission with a jack and wood block under the transmissio

 DTC 45-1x ("x" can be 0 thru 9 or A thru F): No Signal From the Left Side Impact Sensor (second)

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and wait for 10 seconds. 3. Read the DTC. Is

© 2016-2025 Copyright www.hcrv.net