Honda CR-V: Accessory Power Sockets

Your vehicle has two or three
accessory power sockets depending
on the model.

To use an accessory power socket,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Each socket is intended to supply
power for 12 volt DC accessories
that are rated 120 watts or less (10
amps).

None of the sockets will power an
automotive type cigarette lighter
element.

Make sure to put the socket cover
back in place to prevent any small
foreign objects from getting into the
socket.
READ NEXT:
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
DTC 11-1x ("x" can be 0 thru 9 or A thru F):
Open or Increased Resistance in Driver's
Airbag First Inflator
DTC 11-4x ("x" can be 0 thru 9 or A thru F):
Open or Increased Resistance in Driver's
Airbag Second Inflator
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead J
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best picture, always keep the
rearview camera clean, and do not
cover the camera lens. To avoid
scra
© 2016-2025 Copyright www.hcrv.net
