Honda CR-V: Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the radio is turned off.

READ NEXT:

 Playing a Disc (LX model)

Playing a Disc (LX model)

 To Play a Disc

To load or play a disc, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc player with the same controls used for the radio. To select the disc player,

 To Stop Playing a Disc

Press the eject button ( ) to remove the disc. If you eject the disc, but do not remove it from the slot, the system will automatically reload the disc after 10 seconds and put it in pause

SEE MORE:

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remove the boot bands. Be careful not to damage the boot. 3. Make marks (A) on each roller (B) and inboa

 Low Oil Pressure Indicator Circuit Troubleshooting (Open)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2). 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit. 4. Check for DTCs.

© 2016-2026 Copyright www.hcrv.net