Honda CR-V: MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.

1. Turn the ignition switch OFF.

2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T.

NOTE: All connector views are wire side of female terminals.

UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR F (34P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR G (21P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR K (8P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR R (20P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR T (34P)

Honda CR-V. MICU Input Test

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connector still disconnected, make these input tests at the appropriate connector.

Honda CR-V. MICU Input Test

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. MICU Input Test

READ NEXT:

 Keyless/Power Door Locks/Security System

Component Location Index NAVIGATION UNIT or AUDIO UNIT IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) MICU (Built into the under-dash fuse/relay box) HEADLIGHTS HORN HOOD SWITCH SECUR

 System Description

Security Alarm System NOTE: This applies to EX and EX-L models. The security alarm system is armed automatically after the doors, hood, and tailgate are closed and locked. For the system to arm, the

 DTC Troubleshooting

DTC B1026: Front Passenger's Door Lock Switch Signal Error (LOCK/UNLOCK) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Cl

SEE MORE:

 Recommended Tire Pressures

]The following chart shows the recommended cold tire pressures for most normal and high-speed driving conditions. Tire Size Cold Tire Pressure for Normal Driving 225/65R17 102T Front/Rear: 30 psi (210 kPa , 2.1 kgf/cm2 ) The compact spare tire pressure is: 60 psi

 MICU Input Test

NOTE: The MICU turns on the headlights (high beams) in a dim mode for the daytime running lights under the following conditions: The ignition switch is ON (II) The headlight switch is OFF The parking brake is released (parking brake switch OFF) If the vehicle is equipped with an opti

© 2016-2026 Copyright www.hcrv.net