Honda CR-V: Mode Control

Use the mode control buttons to select the vents air flows from. Some air will flow from the dashboard corner vents in all modes.

Air flows from the center

Air flows from the center and corner vents in the dashboard.

Airflow is divided between

Airflow is divided between the vents in the dashboard and the floor vents.

Air flows from the floor

Air flows from the floor vents.

When you select automatically switches to fresh air, the system automatically switches to fresh air mode. If you switch the mode from to or , the system to keeps the A/C on. The A/C, the system keeps the A/C on. The A/C indicator will not come on if it was off to start with.

To turn off the A/C, press the A/C button to illuminate the indicator, then press it again to turn off the A/C.

When you switch to or mode from mode from turns off. But if it was on to start, the A/C turns off. But if it was on to start with, the A/C stays on.

the floor vents and defroster vents at Airflow is divided between the floor vents and defroster vents at the base of the windshield.

vents at the base of the windshield. Air flows from the defroster vents at the base of the windshield.

When you select , or the system automatically switches to, the system automatically switches to fresh air mode and turns on the A/C.

You cannot turn the A/C off in this mode.

READ NEXT:

 Ventilation

The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate. 1. Set the temperature to the lower limit. 2

 Using the Heater

The heater uses engine coolant to warm the air. If the engine is cold, it will be several minutes before you feel warm air coming from the system. 1. Select . When you select , the system

 Using the A/C

Air conditioning places an extra load on the engine. Watch the engine coolant temperature gauge. If it moves near the red zone, turn off the A/C until the gauge reading returns to normal. 1.

SEE MORE:

 Differential Disassembly

Special Tools Required Holder handle 07JAB-001020A Companion flange holder 07RAB-TB4010B 1. Remove the drain plug (A) and the oil filler plug (B) with sealing washers (C). 2. Raise the locknut tab (A) from the groove of the clutch guide, making sure the tab completely clears the groove to preve

 Immobilizer System

Component Location Index IMMOBILIZER INDICATOR IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) UNDER-DASH FUSE/RELAY BOX IMOES UNIT (Built into the MICU) PCM IGNITION KEY TRANSPONDER (Combined with the keyless transmitter) System Description The vehicle is equipped with an im

© 2016-2025 Copyright www.hcrv.net