Honda CR-V: Fan Controls

Component Location Index

Honda CR-V. Fan Controls

Symptom Troubleshooting Index

Honda CR-V. Fan Controls

Circuit Diagram

Honda CR-V. Fan Controls

Radiator Fan High Speed Circuit Troubleshooting

1. Remove the fan control relay from the under-hood fuse/relay box, and test it.

Is the relay OK?

YES-Go to step 2.

NO-Replace the fan control relay.

2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.

Is there battery voltage? YES-Go to step 3.

NO-Replace the under-hood fuse/relay box.

3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.

NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.

READ NEXT:

 Fuel and Emissions

 Fuel and Emissions Systems

Special Tools Fuel Sender Wrench Fuel Pressure Gauge Attachment Set Vacuum/Pressure Gauge, 0-4 in.Hg Pressure Gauge Adapter Oil Pressure Hose A/T Pressure Hose A/T Low Pressure

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

SEE MORE:

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

 Traction

The traction grades, from highest to lowest, are AA, A, B, and C. Those grades represent the tire’s ability to stop on wet pavement as measured under controlled conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performa

© 2016-2025 Copyright www.hcrv.net