Honda CR-V: Compass Zone Selection
In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:
1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode.
2. Select the zone indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.
3. Find the zone for your area on the zone map. Each zone number (1 through 15) corresponds to a compass zone.
4. Turn the select/reset knob to select the appropriate zone number, and press the select/ reset knob to enter the number.
When the system does not accept the selected compass zone, you see ‘‘- -’’ in the direction display. Select appropriate zone number again.
READ NEXT:
Security System
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
Rearview Camera and Monitor
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
Cruise Control
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the
accelerator pedal. It should be used
for cruising on straight, open
highways. It is
SEE MORE:
AuthorizedManuals
Purchasing Factory Authorized Manuals (U.S. only)
The publications shown below can be purchased from Helm
Incorporated. You can order by phone or online:
- Call Helm Inc. at 1-800-782-4356 (credit card orders
only)
- Go online at www. helminc. com
If you are interested in other years or mode
Block and Piston Inspection
1. Remove the crankshaft and pistons.
2. Check the piston for distortion or cracks.
3. Measure the piston diameter at a point 13 mm
(0.5 in.) from the bottom of the skirt. There are two
standard-size pistons (No Letter or A, and B). The
letter is stamped on the top of the piston. Letters
are also
