Honda CR-V: Differential Mount Replacement

Exploded View

Honda CR-V. Rear Differential

Differential Installation

1. Install rear differential mount assembly A to the rear differential assembly (B).

Honda CR-V. Rear Differential

2. Jack up the rear differential.

3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential.

Honda CR-V. Rear Differential

4. Lift the rear differential up into position, then push on both driveshafts to lock the set rings into place.

Connect the breather tube (B).

5. Align the tab (A) of the rubber mount (B) with the hole (C) of the plates (D), then install the plates and torque the rear differential mount assembly mounting bolts (E).

NOTE: The rubber heat insulator (F) is installed only in the right side.

Honda CR-V. Rear Differential

6. Install the breather tubes (G) to the clips (H).

7. Install the right and left rear differential mount brackets B (A), then torque the bolts (B).

Honda CR-V. Rear Differential

8. Install the breather tube (C) to the clip (D).

9. Install the No.2 propeller shaft (A) onto the rear differential (B) by aligning the reference marks (C) made during removal. Make sure you use new mounting bolts (D).

Honda CR-V. Rear Differential

10. Fill the rear differential with the differential fluid to the proper level.

READ NEXT:

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

SEE MORE:

 Moonroof

Component Location Index MOON ROOF SWITCH MOON ROOF CONTROL UNIT/MOTOR Resetting the Moonroof Control Unit Resetting the moon roof is required when any of the following have occurred: The moonroof was moved manually while the battery was dead or disconnected. The moon roof motor was replac

 AuthorizedManuals

Purchasing Factory Authorized Manuals (U.S. only) The publications shown below can be purchased from Helm Incorporated. You can order by phone or online: - Call Helm Inc. at 1-800-782-4356 (credit card orders only) - Go online at www. helminc. com If you are interested in other years or mode

© 2016-2025 Copyright www.hcrv.net