Honda CR-V: To Change or Select Files

Use the SKIP button while a USB flash memory device is playing to change files.

SKIP - Each time you press and release skips forward to the beginning of the (preset 6), the player skips forward to the beginning of the next file. Press and release to  (preset 5), to skip backward to the beginning of the current file.

Press it again to skip to the beginning of the previous file.

FF/REW - To move rapidly within a file, press and hold or  (preset 3). (preset 4) or FOLDER SELECTION - To (preset 3).

FOLDER SELECTION - To select a different folder, press either side of the TUNE bar. Press the and press the  side to skip to the side to skip to the next folder, and press the beginning of the previous folder. side to skip to the beginning of the previous folder.

READ NEXT:

 Using a Track List

You can also select a file directly from a track list on the audio display. Press the AUDIO button to show the audio display, then touch the Track List icon. The track list menu appears on

 To Stop Playing a USB Flash Memory Device

To play the radio, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. Touch the CD icon to switch to the disc mode (if a disc is loaded). Each time you press the CD/XM butto

 Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system. Always follow the USB flash memory device’s instructions when you remove it

SEE MORE:

 Sleep and Wake-up Mode Test

1. Shift to the sleep mode: Turn the ignition switch OFF, and remove the key. If the MICU receives no signals from the inputs listed below, it will go into sleep mode in less than 40 seconds. Driver's door lock switch (LOCK or UNLOCK) Driver's door key cylinder switch (LOCK or UNLOCK) Front pas

 DTC P0325: Knock Sensor Circuit Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed between 3,000 rpm without load (in Park or neutral) u

© 2016-2025 Copyright www.hcrv.net