Honda CR-V: Beverage Holders

Be careful when you are using the beverage holders. A spilled liquid that is very hot can scald you or your passengers. Liquid can also spill from the door pocket beverage holders when you open or close the doors. Use only resealable containers in the door pockets.

Spilled liquids can damage the upholstery, carpeting, and electrical components in the interior.

On vehicles with rear seat armrest

On vehicles with rear seat armrest

The rear seat also has a beverage holder in the center armrest. To use it, pivot the armrest down.

READ NEXT:

 Center Table

On LX and EX models To use the center table, pull up the outside edge of the table until it latches. To store it, pull the lever and lower the table. Sitting on or getting under the ta

 Lower Glove Box

Open the lower glove box by pulling the bottom of the handle. Close it with a firm push. Lock or unlock the glove box with the master key. The glove box light comes on when the parking li

 Upper Glove Box

Open the upper glove box by pushing up the lever. Close it by pulling down on the edge under the lever.

SEE MORE:

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

 A/T Clutch Pressure Control Solenoid Valve

A/T Clutch Pressure Control Solenoid Valve A Test 1. Connect the HDS to the DLC (A). 2. Choose Clutch Pressure Control (Linear) Solenoid A in the Miscellaneous Test Menu on the HDS. NOTE: If the HDS does not communicate with, the PCM, troubleshoot the DLC circuit. 3. Test A/T clutch pressure contr

© 2016-2025 Copyright www.hcrv.net