Honda CR-V: Vanity Mirror

To use the vanity mirror on the back

To use the vanity mirror on the back of the sun visor, pull up the cover.

Except LX model

The vanity mirror lights come on when you pull up the cover.

READ NEXT:

 Sun Visor

To use the sun visor, pull it down. When using the sun visor for the side window, remove the support rod from the clip, and swing it out. Make sure you put the sun visor back in place when

 Sunglasses Holder

To open the sunglasses holder, push then release the raised detent. It will unlatch and swing down. To close it, push it until it latches. Make sure the holder is closed while you are driv

 ConversationMirror

The sunglasses holder uses a convex mirror for its bottom panel. You can see all the vehicle passengers in this mirror. To use the mirror, open the sunglasses holder fully, push it to the

SEE MORE:

 Piston Ring Replacement

1. Remove the piston from the engine block. 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring or ring groove cleaner with a blade to fit the piston grooves. The top and 2nd ring grooves are 1.2 mm (0.05 in.) wide. Th

 Engine Compression Inspection

NOTE: After this inspection, you must reset the powertrain control module (PCM), otherwise the PCM will continue to stop the injectors from functioning. Select PCM reset using the Honda Diagnostic System (HDS). 1. Warm up the engine to normal operating temperature (cooling fan comes on). 2. Turn t

© 2016-2025 Copyright www.hcrv.net